BendPak RS7580V-601, Инструкция по установке и эксплуатации, Страница: 21 / 44

RS7580V-601 Rotary-Screw Air Compressor
21
P/N 5900090 — Rev. A — Sept. 2019
Check the Oil Level
The Compressor comes filled with oil/lubricant.
The amount of oil
must
be between the two red lines while the Compressor is
running
.
Not necessarily to scale. Not all components shown.
Important : When the Compressor is off or has been stopped for over 30 minutes, the oil level will
rise; it will be
above
the top red line ; this is normal. This includes when you initially
receive the Compressor; the oil level will be above the top red line.
⚠
WARNING
Do not overfill or under fill the oil. If you overfill, there could be too much oil in the
pressurized air. If you under fill, the Compressor could overheat and be
permanently damaged, which voids the warranty.
If you require additional oil, get 46 HT Synthetic Compressor Oil.
You are looking for:
•
Viscosity, cSt @ 40°C
: 46.0
• Viscosity Index : 139
Connect the Discharge Port
Connect the Tank’s Discharge Port to the facility’s Air Pressure infrastructure.
⚠
WARNING
Do
not
route compressed air through PVC. It could get brittle and then crack or
burst, which could cause damage to the facility and injure bystanders. All
components of the facility’s Air Pressure infrastructure must have a pressure rating
of 200 psi or greater.
If the facility does not already have an Air Pressure infrastructure, you need to create one.
Creating an Air Pressure infrastructure is out of the scope of this document; BendPak recommends
consulting with a professional.
To gather information on the subject for yourself, search the Internet for “compressed air system for
shop”; you will find products, videos, and articles.