BendPak RJ-12, Инструкция по установке и эксплуатации

Страница: 15 / 28

15
WEEKLY MAINTENANCE
1. Lubricate all rollers with general purpose oil or
WD-40.
2. Check all Hose connections, bolts and pins to insure
proper
mounting.
3. Lubricate Safety lock pivot points with general
purpose oil or WD-40.
4. Check and tighten Cylinder Bolt. (See Fig. 7.4)
MONTHLY MAINTENANCE
1. Lubricate the Cylinder Pin and Main Hinge Pin with
all purpose grease using a needle point lube coupler.
(See Fig. 7.5 & 7.6)
2. Check Safety Locks to insure they are in good
operating
condition.
3. Make a visual inspection of ALL MOVING PARTS
and check for excessive signs of wear.
4. Replace ALL FAULTY PARTS before lift is put back
into operation.
NEVER EXCEED THE RATED CAPACITY of lift.
DO NOT USE LIFT if any component is found to be
defective or worn.
NEVER OPERATE LIFT with any person or
equipment below.
ALWAYS STAND CLEAR of lift when lowering or
raising.
ALWAYS INSURE SAFETY LOCKS ARE
ENGAGED before entering work area.
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all four safety locks are engaged.
Fig. 7.4
Fig. 7.5
Fig. 7.6