BendPak RBJ15000, Инструкция по установке и эксплуатации

Страница: 11 / 32

RBJ Series of Rolling Jacks
11
P/N 5900004 — Rev. D1 — October 2020
• You can only use the Rolling Bridge Jack in certain locations on the Lift . This is
because the strength of the Lift is less in the middle, so raising a Vehicle in the middle could
permanently damage the Lift’s Runways. In the vast majority of cases, this unusable area in the
middle of the Lift will not impact your use of your Rolling Bridge Jacks, as the length of the
wheelbases of the Vehicles you are raising will put the Rolling Bridge Jacks in the usable area.
⚠
CAUTION
Using Rolling Bridge Jacks in the middle of the Lift could permanently damage the
Lift’s Runways.
Damage caused by this unsupported use of Rolling
Bridge Jacks is not covered by the warranty.
Not necessarily to scale. Not all components shown.
So what does this information mean:
•
If you are using
one
Rolling Bridge Jack on your Lift, do not use it in the unusable area.
• If you are using
two
Rolling Bridge Jacks on your Lift, center the Vehicle between the Front and
the Back of the Runways, over the area that is not usable for Rolling Bridge Jacks. This gives you
the most room on the ends (the usable areas) for your Rolling Bridge Jacks.
• If you are using two Rolling Bridge Jacks, they must never be closer to each other than 30% of
the length of the Runway of the Lift they are on, nor can either one be used in the unusable area.
Check the Specifications of your Lift for the length of the Runways and additional information.