BendPak RBJ15000, Инструкция по установке и эксплуатации

Страница: 16 / 32

RBJ Series of Rolling Jacks
16
P/N 5900004 — Rev. D1 — October 2020
Setting Up the Air-Operated Hydraulic Pump
Your Rolling Bridge Jack comes with an Air-Operated Hydraulic Pump, which provides air pressure so
you can raise and lower the Jack.
It is your responsibility to supply air pressure to the Pump .
The Air-Operated Hydraulic Pump comes from the factory with Hydraulic Fluid. You do not need to
add any at this point, unless the Hydraulic Fluid has leaked out. Checking the Hydraulic Fluid level is
described in the next section.
Air pressure should be set to 20 cubic feet per minute (.57 cubic meters per minute) and
100 psi (7 bar).
Do not exceed 125 psi (8.6 bar) at any point; you could damage the Air-Operated Hydraulic Pump.
⚠
WARNING Before performing installation or maintenance, release the air pressure currently in
the system, then disconnect the pump at the Air Intake Valve. If you do not release
the air pressure in the system, anyone working on the Jack or nearby could be
injured (or, in rare cases, killed) by an unexpected release of energy.
To set up your Air-Operated Hydraulic Pump :
1. Remove the thread protector from the Air Intake Valve on the Pump.
2. Install a threaded fitting (not supplied) that is compatible with your air supply into the Air Intake
Valve.
3. Connect your air pressure supply to the threaded fitting you just installed on the Pump.
⚠
CAUTION An appropriate Air Line regulator and water separator must be installed on the air
pressure supply line.
Failure to install these items could lead to damage
and voids the warranty on pneumatic components.
4. Loosen the Vented Fill Cap approximately one turn counterclockwise before starting normal
operation (it was tightened for shipment).