BendPak HD-9AE, Инструкция по установке и эксплуатации

Страница: 32 / 52

32
LIFT OPERATION SAFETY (CONT’D)
• ALWAYS
keep area around lift free of tools, debris,
grease and oil.
• NEVER overload lift. Capacity of lift is shown on
nameplate affixed to the lift.
• DO NOT
stand in front of the vehicle while it is being
positioned in lift bay.
• DO NOT block open or override self-closing lift con-
trols; they are designed to return to the “Off” or Neutral
position when released.
• ALWAYS remain clear of lift when raising or lowering
vehicles.
• ALWAYS
use safety stands when removing or installing
heavy components.
• DO NOT go under raised vehicle if safety locks are not
engaged.
• NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all Safety Locks are engaged.
• AVOID excessive rocking of vehicle while on lift.
• ALWAYS CLEAR AREA if vehicle is in danger of falling.
• ALWAYS REMOVE tool trays, stands, etc. before low-
ering lift.
• ALWAYS RELEASE
safety locks before attempting to
lower lift.
• DO NOT position yourself between a wall and the lift.
If the vehicle falls in that direction, you may be severely
injured or killed.
To Raise Lift
;
1. Position vehicle tires in the center of each Runway.
2. Set parking brake and use Wheel Chocks to hold
vehicle in position.
3. Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances.
4. Raise the lift to the desired height by pressing the
push button on the power unit.
5. After vehicle is raised to the desired height, lower the
lift onto the nearest Safety Lock. Do not allow Cables to
become slack. ALWAYS ENSURE ALL SAFETY LOCKS
ARE ENGAGED before entering work area.
To Lower Lift
;
1. Before lowering vehicle, be sure all personnel are
clear of the lift and surrounding area. Pay careful atten-
tion to overhead clearances. Ensure all tools and equip-
ment have been cleared from under the lift.
DANGER!
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY
LOCKS ARE ENGAGED BEFORE ENTERING WORK
AREA. SUSPENSION COMPONENTS USED ON THIS
LIFT ARE INTENDED TO RAISE AND LOWER LIFT
ONLY AND ARE NOT MEANT TO BE LOAD HOLDING
DEVICES. REMAIN CLEAR OF ELEVATED LIFT
UNLESS VISUAL CONFIRMATION IS MADE THAT ALL
PRIMARY SAFETY LOCKS ARE FULLY ENGAGED AND
THE LIFT IS LOWERED ONTO THE SAFETY LOCKS,
REFER TO INSTALLATION/OPERATION MANUAL
FOR PROPER SAFETY LOCK PROCEDURES AND/OR
FURTHER INSTRUCTION.
WARNING!
WHEN LOWERING THE LIFT PAY CAREFUL ATTEN-
TION THAT ALL PERSONNEL AND OBJECTS ARE KEPT
CLEAR. ALWAYS KEEP A VISUAL LINE OF SIGHT ON
THE LIFT AT ALL TIMES. ALWAYS MAKE SURE THAT
ALL LOCKS ARE DISENGAGED. IF ONE OF THE LOCKS
INADVERTENTLY LOCKS UPON DESCENT THE VE-
HICLE MAY DISMOUNT CAUSING PERSONAL INJURY
OR DEATH.
NOTE:
ALLOW (2) SECONDS BETWEEN MOTOR STARTS.
FAILURE TO COMPLY MAY CAUSE MOTOR BURNOUT.