KGX 150/130 Transceivers and Receivers
D201405000060
REV 0
Oct 2014
KGX Control Panel
2-4
Honeywell International Inc. Do not copy without express permission of Honeywell.
ALT
-- The KGX 150T/130T is placed in
Airborne
Transmission
Mode
or
automatically switches between Airborne
and Ground Mode if an Air/GND Squat
switch is configured and the aircraft
velocity meets the criteria described in
DO--282B for the specific aircraft configuration. Pressure altitude is
reported.
NOTE:
There is no functional difference between the two
ALT
knob
positions.
ON
-- The KGX 150T/130T is placed in
Airborne
Transmission
Mode
or
automatically switches between Airborne
and Ground Mode if an Air/GND Squat
switch is configured and the aircraft
velocity meets the criteria described in
DO--282B for the specific aircraft configuration. Pressure altitude
reporting is suppressed.
NOTE:
When airborne, the control panel should always be set to
either of the two ALT positions, unless otherwise directed by
ATC.
CODE KNOB
The Code knob is used to set squawk codes, such as those listed in
Table 2--1, and the Flight ID. Push the Function (
FN
) button until either
the squawk code or Flight ID is highlighted at the top of the screen.
Turning the Code knob, shown in Figure 2--4, will highlight the first digit
on the display, and the digit can be changed as required by rotating the
Code knob. Push the Enter (
ENT
) button to advance to the next digit.
When
ENT
is pushed on the last digit, the new squawk code or Flight
ID will replace the previous value. If the code entry is not completed
within 7 seconds, the changes are ignored and the previous code is
restored.
Figure 2--4
CODE Knob
