BENDIXKing 700-00179-700, Руководство по установке, Страница: 131 / 228

89000046-014 KSN 780/8XX/900 AeroNav AML STC Installation Manual for Helicopters
Rev 0 Page 10-4
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Figure 40 Update Complete Indication
When you are all done press the “Done” LSK, which will restart the AeroNav into flight mode. Remove
the USB fob and perform a normal start up. It is highly recommended to verify the data was updated
from the “Setup” LSK of the SYSTEM tab on the AUX page.
If an AeroNav is in normal operating mode (not maintenance mode), the presence of a USB fob is
ignored and these pages cannot be accessed.
10.2 Datalogs Download
There is extensive data-logging that is automatically done on all AeroNav s. These datalogs can be
accessed post-flight and used for a number of purposes.
There are five types of datalogs employed in the AeroNav s:
•
System Log –
This log provides an in-depth record of the navigation
state. From this log, you can re-create many aspects of the FMS output
and AeroNav state. It logs at a rate of approximately 1Hz;
•
Flight Log – This log provides a detailed record of your aircraft state as
measured by the various AeroNav sensors. It logs at a rate of
approximately 5Hz;
• Engine Log – This log provides details on fuel flow sensor data (if
configured). It logs at a rate of approximately ¼ Hz;
•
Event Log – This log contains miscellaneous data such as all alerts,
keystrokes, system status and error messages, etc. It is designed to be
diagnostics log for BendixKing Technical Support technicians and not
expected to be used by owners/operators. It logs at an on-condition
rate;
• Voltage Log – This log contains internal diagnostic data such as the
voltages and currents on sub-system boards, temperatures and
internal fan status. It logs at a rate of approximately 1Hz.