13
Exemplary drawing.
Air supply requirements
•
Supply tool with a maximum pressure according to the technical data of this unit of clean,
dry air. Higher pressure drastically reduces tool life and/or can cause several injury.
•
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
•
Do not install a quick coupler directly into the air tool handle.
•
In order to have the tool working to full satisfaction the minimum air delivery must be at
least 10% higher than the indicated air consumption of the air tool.
•
Please consult the technical data in this instruction manual.
Pneumatic tool and safety instructions
•
The goal of Bendel Werkzeuge is to offer tools that help your work safely and efficiently.
•
The most important safety device for this or any tool is YOURSELF.
•
Your care and good judgment are the best protection against injury. All possible hazards
cannot be considered here, but we have tried to highlight some of the most important
ones.
•
This tool may only used by qualified people.
•
This tool and its accessories must not be modified.
•
Do not lay down the device before all the rotary parts stopped.
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken.
•
Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and
do not switch on again until the problem is solved. Understand the reason why the tool
has been blocked and make sure that this situation will not occur once more by
counteract accordingly.
