16
5240-552
Wheels
1. Remove disposable spindle covers and wheel bearing covers.
2. Slide Wheel/Tire to the spindle with valve stem
of tire facing outwards. Install the Flat Washer onto
the spindle. Thread the slotted Castle Nut onto the
spindle. The slotted nut should be attached with a
28mm socket tight enough to eliminate the freeplay
of the wheel assembly and not tighter. Make sure
the wheels can freely rotate. The Castle Nut needs to
be oriented to allow for the installation of the Cotter
Pin. Install the Cotter Pin through the Castle Nut and
spindle. Bend pin ends around spindle to secure its
position. Install the Hub Cap using the Hub Cap
Tool. Gently tap on the hub cap tool with a hammer
to drive the hub cap into place. Repeat these steps
to install the 2nd wheel.
Installation of the cotter pin is important
and required. Failure to install the cotter
pin can result in loss of wheel retention.
Always assemble using a new cotter pin.
Do not reuse.
Tank & Tongue
1. Attach the Tongue & Stand to the Tank & Engine
with Hex Bolt M12 x 110 mm, Flat Washer, Lock
Washer and Hex Nut in two places. Tighten securely
using 19mm socket wrenches.
2. Remove the cap from the manual canister. Align
the holes in the manual canister with the holes in
the tongue. Insert and tighten bolts and washers.
Put the cap back on the canister.
M12 x 110
( 2)
M12
×
110
×
2
Содержание 65926
Страница 20: ...19 25 TON LOG SPLITTER OWNER S MANUAL FEATURES AND CONTROLS...
Страница 31: ...30 5240 552 PARTS DIAGRAM...