5
15.
Install the two Hinges (27) by pressing the
cups into the pockets in the Door (11), and
turning the integral cam fasteners.
Fig. 11.
Do not overtighten the cam.
16.
Clip the Door (11) onto the cabinet.
Fig. 11 inset.
17.
Install the center-door stop dowel by
placing one wood dowel (24) and a dab of
woodworking glue into the
lower
hole, as
shown in
Fig. 12.
18.
Install the Door Handle (23) using the
included hardware.
Fig. 12 inset.
19.
Install four Wood Dowels (24) into the
cabinet, as shown in
Fig. 13.
Place a dab of
woodworking glue on the dowels to keep
them in place. These dowels will support the
router bit storage covers.
20.
Press the four Nylon Spring Pins (30) into the
router bit storage covers using a flat surface.
Note:
When pins are fully depressed, they
will be flush with the surrounding surface.
The pins will stand proud of the surrounding
surface when not depressed.
21.
Install the two Bit Storage Covers (12) onto
the cabinet, as shown in
Fig 14.
Note the
left and right orientation of the doors. You
will have to depress the spring pins and
align them with the routed grooves. The
covers will snap into the routed grooves in
the surrounding panels. Be sure to first
place the covers
above
the two wooden
dowels. If you must remove the covers from
the cabinet, first slide the covers all the way
back on grooves, then push up at the rear
and lift away.
22.
Install two Storage Door Locks (31), as
shown in
Fig. 15.
Note:
If you need to adjust the tension,
gently pry apart the clip with a flat-head
screwdriver, as shown.
C
ABINET ASSEMBL
Y
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
27
12
30
31
