3
1.
Attach the Drawer Divider (2) to the Shelf (1),
as shown in
Fig. 1
. Use two 1/4-20 x 2"
round-head bolts (13) and two steel
cross-dowels (19). Place a dab of thread-lock
on the end of the bolts and tighten using the
supplied 4mm Hex Wrench. Always install the
cross dowels before the bolts.
2.
Follow the same procedure used in Step 1 to
attach the Drawer Divider (2) to the Bottom
(3), once again using two 1/4-20 x 2"
round-head bolts (13) and two steel cross
dowels (19).
Fig. 2.
3.
Install eight wood dowels (24) into the Shelf (1)
and Bottom (3), as shown in
Fig. 3.
Do not
glue the dowels, they are for alignment
purposes only. Be sure to place them in the
correct holes, which have a single hole drilled
through the end of the panel. The other holes
in the panels are double-drilled for use with the
bolt and steel cross dowels. These
double-drilled holes have
two
holes that
intersect, one through the top or bottom of
the panel, and the other through the end of
the panel.
4.
Place the shelf assembly onto the Left Side
Panel (4), as shown in
Fig. 4.
5.
Place the Right Side Panel (5) onto the shelf
assembly. This panel is marked "R" on the
inside. Be sure to fit the dowels into their
proper holes.
6.
Bolt the Right Side Panel (5) to the shelf
assembly using four 1/4-20 x 2" round-head
bolts (13) and four steel cross dowels (19).
Install the cross dowels first. Use the 4mm
hex wrench to lightly tighten the bolts. You
will fully tighten the bolts after the cabinet is
fully assembled.
Fig. 5.
7.
Follow the same procedure to bolt the Left
Side Panel (4) to the shelf assembly.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
C
ABINET ASSEMBL
Y
1
2
2
1
3
2
3
1
4
5
