200686_4
Page 2
Please unpack carefully ensuring that any loose parts and all packing items are removed. Read any warning labels carefully (see maintenance
section). Place waste packaging back into box and dispose of RESPONSIBLY.
The surround / appliance must be positioned so that plug (fused spur) is accessible. Only when you are certain that you
have completed the installation should you plug in and switch on at the wall socket.
Suite Installation
Before You Start
The appliance Data Plate is located Underneath the Heater-box Check and make sure you have all the parts as listed
above. If not, contact:
Be-Modern Helpline on 0191 430 0901
.
Finishing Touches
Prior to installation please remove the transit pads at the base of the Suite “A” (If attached)
Place Suite “A” in the required position and remove any obstructions, i.e. cut to shape or remove skirting to allow the Suite to
butt up flush against the wall (if required). Remember to allow enough space when cutting the skirting for the cable to exit from
the desired side.
Tools Required for Wall Fixing suite
mounted version. (Not supplied)
Drill, Cross Head Screwdriver, Wall plugs, Pencil, Ruler
Tape Measure, 2 Screws
Fixing suite to the Wall (If required)
1 - Screw the 2 off Mirror brackets (B) to the rear of each leg
at 100mm from the top of the suite using the 4 - off 5/8”
screws (C) see
Fig.1
2 - Offer the suite to the wall and mark the wall with a pencil
in the smaller hole of the mirror plate
Fig.2
3 – Lift suite away from the wall then drill and plug the holes
with suitable fixings dependant on types of wall.
4 – Offer the suite back to the wall and line up the mirror
plates with the holes in the wall
5 - Fix to the wall using two screws (not supplied) See
Fig.2
6 – N.B. This suite is supplied as a 1 piece product.
7
– Do not seal suite to the wall (I.e. using Silicone)
8 - The fire will be supplied installed into the surround.
Remove the 2 x Transit screws going into the hearth from
rear of the fire.
Should a defect occur and in the event of the suite being
fixed to the wall, the householder should be aware of the
following:-
They are fully responsible for the removal of the faulty suite
and the fitting of the replacement. Any costs incurred during
the removal and re-fitting of a replacement suite are the
responsibility of the householder.