200688_6
Page
3
Trims (various)
If your appliance is supplied with a trim please follow the below guidelines for fitting
1 Piece trim (3 sided)
IMPORTANT: The trim is located in the rear of the surround. Do not discard trim with packaging.
Please use the following instructions as a guide for fitting the optional 1 piece metal trim (only available with selected models).
Note- remove the protective plastic film from the trims prior to the following steps.
Position the magnets on the insides of the trim, 2 at the top and 1 each side on the legs spreading them out evenly as to get a strong pull on the fire
metalwork.
Place the base of the trim against the fire frame as shown in
Fig.5
. and push the top of the frame towards the top of the fire ensuring that the trim
does not slip with the pull of the magnets, The trim installation is now complete.
Fig 5.
1 Piece trim (Painted Trim):
To attach the decorative trim, align the trim feet in position with the fire and push the top in securely so that the magnets can get a strong grip on the
metalwork. The trim installation is now complete.
3 Piece trim (3 Sided)
IMPORTANT: The trim is located in the rear of the surround, on top of the fire. Do not discard trim with packaging.
Please use the following instructions as a guide for fitting the optional 3 piece metal trim (only available with selected models).
Note- remove the protective plastic film from the trims prior to the following steps.
Position the magnets on the insides of the three trim parts (left, right and top) spreading them out evenly as to get a strong pull on the fire
metalwork.
Place the left hand trim vertically against the fire frame as shown in
Fig.6
. Note- you should feel the magnets pulling the trim into place. Repeat this
process using the right hand side and finally the top trim on the relevant sides. (see
Fig.7
). When locating the top trim make sure the sides sit flush
with the outer edge.
The trim installation is now complete.
Fig.6
Fig.7
