BEMIS bioBidet Prodigy P700, Руководство пользователя

Страница: 16 / 21

30 31
TROUBLESHOOTING
If the product is not functioning properly, check the following troubleshooting
tips. If the problem persists, please contact Bio Bidet support department.
Power Supply
Trouble
Possible Causes Solution
The unit is not
working. Is the power out or
circuit breaker off? Wait until the power is
restored, or turn on the
circuit breaker.
Is the operation light on
the display panel off? Turn on the power in the
control panel of the main body.
Posterior Wash, Feminine Wash, Enema, Kid Function
Trouble
Possible Causes Solution
Water is not
spraying out. Is the shutoff valve closed? Open the valve
Is the seat sensor
being activated? Make skin contact with
the seat sensor.
Is the hose crimped? Reposition the hose.
Water pressure is
too low Is the water pressure
set too low? Increase the water
pressure and clean
the nozzle
Is there any debris in
the hose? Turn off the water
shutoff valve and clean
the hose out.
Water is cold. Is the temperature set to a
low level or turned off? Adjust with the
+/- buttons on the
remote control.
Is power saving mode
turned on? The water temperature is
set lower and increases
when seated.
Water stops
in the middle
of cleansing. The cleaning functions
automatically and stops
after five minutes of use. Press a cleansing function
button again.
Is the seat
sensor activated? Make skin contact with
the seat sensor.
Water flows into
the toilet for a few
seconds near the
nozzle when first
sitting down. When the seat sensor is
on, it releases some water
before spraying. If you
change the position while
seated, the sensor will turn
on and off, and release
some additional water. -