30
1. Guidance on Unpacking and Installation
USE Guide and Maintenance
1.
Open the packing case; take out the top foam and its ac-
cessories.
2.
Put the accessories aside.
3.
Unpack the product.
4.
Before installation, to study the use of the quick connector.
4.1.
Connect tubes:
4.1.1.
Push tubing through collet until it engages the O-ring.
Continue pushing until the tube bottoms out against the back
of the fitting. A common mistake is to stop pushing when the
tube engages the O-ring. This will lead to future leaks. When
the tubing is fully engaged, 20 mm of the tube has entered the
fitting (Figure 1).
4.1.2.
If using tubing other than that supplied with the system,
be sure it is of high quality, exact size and roundness with a
smooth surface.
4.2.
Disconnect tube:
4.2.1.
Push the collet inward with finger tips and hold it.
4.2.2.
Pull the tubing out.
5.
Use the fixed block fixing the machine to the floor.
100 mm
Please cut off water source before replacing filters. Newer plug filters in water running state.
Figure 1
Tube, partially engaged with fitting
Tube, fully engaged with fitting
Collet
Collet
O-ring
O-ring
Safety
precautions
Product
introduction
W
orking
principle
USE Guide & maintenance
Using the product
trouble-
shooting
