4 Care and Maintenance
GB
User Instructions HairMaster® | 751 250
52
To dismount the radiant heaters:
Replacing the radiant heater
The radiant heaters are attached to their base by means of spring pressure.
• To dismount a radiant heater, push one side into its base and then
remove the opposite contact block
a
from the radiant heater
base
9
.
To re-mount the radiant heater:
1. To prevent finger prints being burnt into the radiant heater glass,
never touch it without protective gloves or a clean, soft cloth.
2. To mount the radiant heater, place one side into the base and then
push it down in order to ensure that the contact block on the opposite
side can be inserted into the base.
3. Check for the safe positioning of the contact blocks in the bases.
To re-mount the protective grid of the main heater:
1. Insert the locking pins of the heater protective grid into the two upper
bore holes.
2. Using a screwdriver, lift the heater protective grid and insert the
locking pins
4
into the bore holes
2
.
3. Check for the safe positioning of the heater protective grid.
4. Remove the adhesive tape (if required).
To re-mount the heater protective grid of the side arm:
1. First, insert the locking pins of the heater protective grid into the bore
holes located on the side facing the side arm bearing.
2. Next, push the locking pins
7
of the heater protective grid into the
bore holes
5
at the end of the side arm.
3. Check for the safe positioning of the heater protective grid.
4. Remove the adhesive tape (if required).
_GA_HairMaster_GB.book Seite 52 Donnerstag, 6. September 2012 10:09 10
