Belshaw Brothers Donut Robot Mark II, Руководство оператора

Страница: 5 / 57

Belshaw Adamatic Bakery Group

www.belshaw-adamatic.com

206-322-5474

service@belshaw.com
Donut Robot Mark II OM MN-1012EN 1
1 Operation
Read each step completely before doing what it
tells you to do.
Making Cake Donuts
1. If necessary, install the swing column,
connect the swing connecting rod, install the
cutter head, and install the hopper and the
plunger.
2. When the shortening reaches the correct
frying temperature, it should reach the top of
the flight bars.
Shortening expands as it increases in
temperature. This means that unless the
shortening is at frying temperature when you
put it in the kettle, you should put it in
gradually. Let the shortening in the kettle
heat up before you add more.
Put shortening in the kettle using one of
these methods:

Pre-melt shortening in a pan on the stove
and carefully pour it into the kettle.

Use the optional EZ Melt to melt
shortening and transfer it to the kettle.
See your EZ Melt manual.
WARNING
Hot shortening causes severe burns.

Put solid shortening into the kettle,
packing it tightly around the elements
and bulbs.
WARNING
Air spaces can cause the shortening to
overheat and catch on fire.
3. Turn the heating element on by turning the
thermostat knob above 200

F/93

C. Two
pilot lights will come on. The one on top of
the heater head indicates that the heating
element has been turned on (that the
thermostat is set above 200

F/93

C). The
one on the front of the heater head indicates
that the shortening has not yet reached the
desired temperature. This light will go out if
the high temperature limit control breaks the
circuit.
Note: If the high temperature limit control
does break the circuit, push the red reset
button on the back of the heater head.
4. Wait for the shortening to reach the desired
temperature. When it does, the pilot light on
the front of the heater head will go out. DO
NOT run the conveyor until all the
shortening has melted.
5. If you are using the optional Shortening
Reserve Tank, fill it with shortening. Then
position it on the conveyor side panels either
ahead of or behind the turner, but not above
it. The heat of the fryer will melt the
shortening in the tank.
6. Disengage the swing connecting rod from
the swing column throw arm and swing the
hopper away from over the fryer.