Belshaw Brothers Donut Robot Mark II, Руководство оператора

Страница: 34 / 57

Belshaw Adamatic Bakery Group

www.belshaw-adamatic.com

206-322-5474

service@belshaw.com
2 MN-1013EN Donut Robot Mark II TS
Unpacking the Fryer
To unpack the Donut Robot

Mark II. First
transport the Mark II to the workstation:
1. Remove the foam and other packing
materials from the two boxes.
2. Carry the hopper, plunger, and column to the
workstation.
3. Coil the cutter head power cord and carry
the cutter head to the workstation.
4. Carry the conveyor assembly to the
workstation.
5. Remove the clevis pins that hold the heater
head in place, and lift the heater head out of
the fryer.
6. Coil the power cord and carry the heater
head to the workstation.
7. Move the fryer case and kettle to the
workstation.
Initial Cleaning
Thoroughly clean your Donut Robot Mark II
before using it. Remove all packing materials.
Use household dishwashing detergent.
Do not
use strong alkali cleaners such as lye, soda
ash, or trisodium phosphate
. Thoroughly dry
and lubricate parts to prevent rusting.
Refer to the Cleaning section in the Operator's
Manual for detailed cleaning instructions.
WARNING
To avoid electrocution or damaging the
machine, never allow water, steam,
cleaning solution, or other liquid to enter
the cutter head or heater head assemblies.
WARNING
Never let water and hot shortening come in
contact. Moisture causes hot shortening to
spatter, which may cause serious injury.
Prior to use, make sure any parts you have
washed are dry.
After cleaning, assemble the fryer and cutter as
explained below.
Assembling the Fryer
1. Place the fryer case on a flat, stationary
surface.
2. Screw the fryer’s legs in as far as they will
go.
3. Set the kettle into the fryer case. The end of
the kettle that has the locating pin must be
placed at the outfeed end of the fryer case.
The lip of the kettle should fit securely over
the edge of the case.
4. Install the heater head assembly as follows:
a. Align the holes in the heater head end
caps with the holes in the heater head
mounting brackets.
b. Slide the clevis pins through the holes so
that the pinheads are on the outsides.
c. Insert the hairpin clips into the holes in
the clevis pins.
5. Lower the heater head assembly into
position so the thermostat bulb bracket rests
on or very near the bottom of the kettle.
6. Install the conveyor assembly as follows:
a. Hold the conveyor at the angle shown in
Figure 1-2 and slide the conveyor drive
coupling over the main drive shaft
coupling. The conveyor coupling has a
notch in it. Turn the conveyor coupling
until the head of the socket head screw
in the drive coupling can slide into this
notch. (See Figure 1-2.)