O W N E R S M A N U A L
Figure 14
Figure 13
Figure 15
Figure 16
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 10
Assembly of Planter
7.
STEP
Figure 9
Figure 11
High Setting
Low Setting
Figure 12
Take out Inner Water Bowl, remove any bird feed if converting from a bird feeder, remove the three Bird Feeder Covers in the Base (Figure 1-7) and reinsert the Inner Water
Bowl (Figure 6). Please Note: Please remove the packing material inside Fountain Tower that says “REMOVE BEFORE USE” (Figure 7).
Add soil and plants to the Base (arrows in Figure 13). Do not remove the Water Bowl while there is soil and plants in the Base.
Insert the fully assembled Fountain Tower into the center of the Inner Water Bowl. There are two height options for the fountain (See Diagram 1a and Figure 9 and 10 of this step
and 9-10 of step 6). To lower the height, align the feet of the Fountain Base to the bottom of the Inner Water Bowl. To raise the Fountain height, align the feet to the raised step on
the Inner Water Bowl. Make sure the Fountain is secure before proceeding to the next step.
Fill Inner Water Bowl with water till it reaches the minimum water level ring on the Fountain Base(Figure 11 and Diagram 1a).
Add soil to the Base. Do not remove the Inner Water Bowl while there is soil in the Bottom Bowl (Figure 13).
Insert the Wire Cable into the hole located on the side of the Base. Thread the other end of the Wire Cable through the loop and connect it to the Hook (Figure 14-16).
Repeat this step for the other two Wire Cables (Figure 16).
Fleur Deluxe 3-In-1Bird Feeder, Bird Bath & Planter
TM
