O W N E R S M A N U A L
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 10
Assembly Of Bird Feeder:
6.
STEP
Figure 9
Top Hieght
Adjustment
Bottom Hieght
Adjustment
Top Height
Adjustment
Bottom Height
Adjustment
Top Height
Adjustment
Bottom Height
Adjustment
Top Height
Adjustment
Bottom Height
Adjustment
Figure 11
Figure 12
Figure 14
Figure 13
Figure 15
Figure 16
In this step you will install the 3 Bird Feeder Covers into the Base. These 3 Bird Feeder Covers install over the 3 holes in the base and enable you to fill the area with bird seed
once the fountain is completely assembled (Figure 1-4).
Note: Be sure to place the Base of your fountain on a flat, firm surface. The 3 Bird Feeder Covers will install in the 3 areas marked with the arrows. All 3 covers are exactly the same.
Insert Inner Water Bowl (Figure 5-7).
Insert the fully assembled Fountain Tower into the center of the Inner Water Bowl. There are two height options for the fountain (See Diagram 1a, Figure 9-10 and Figure11-12
of step 7 ). To lower the height, align the feet of the Fountain Base to the bottom of the Inner Water Bowl. To raise the Fountain height, align the feet to the raised step on the
Inner Bowl. Make sure the Fountain Tower is secure before proceeding to the next step.
Fill Inner Water Bowl with water until it reaches the minimum water level ring on the Fountain Tower (see Diagram 1a and Figure 11).
Add bird seed to the Bottom Bowl (Figure 12). Do not remove the Inner Water Bowl while there is bird seed in the Bottom Bowl (Figure 13).
Insert the Wire Cable into the hole located on the side of the Bottom Bowl. Thread the other end of the Wire Cable through the loop and connect it to the Hook (Figure 14-16).
Repeat this step for the other two Wire Cables (Figure 16).
Fleur Deluxe 3-In-1Bird Feeder, Bird Bath & Planter
TM
