Cabinet Construction For Your Appliance
The sizes of the unit for installing the appliance under
a worktop or in a column unit are shown in figure.
To provide adequate ventilation, there must be
appropriate ventilation opening, the panel to which
the oven is fitted should have a gap of at least 70 mm
at the rear.
The unit panels next to the appliance must be heat
resistant. In the case of veneered wood units, glues
must be resistant to a temperature of 120
°
C.
Fitting Your Appliance
Fit the appliance into its surround (beneath a work-top
or above another appliance) by inserting screws into
the 2 holes that can be seen in the frame of the oven
when the door is open.
Note:
Your appliance must be mounted on a flat surface for
the full width and depth of the product
Connect Power Supply Cord
Pull open terminal board cover at rear panel of
appliance.
Fit wires through on terminal board and make
connections to terminals.
Engage wires into plastic clip. Secure plastic clip
with supplied screws.
Close the terminal board cover.
Mounting Screws
Plastic clip
Plastic clip
Securing
6
GSM Retail Australia
Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: 1300 373 199
Aust OR 0508123108 NZ
www.belliniappliances.com.au
Model: BOT605BX-F 60cm Built In Oven
Hard Wired Appliances :
When making the mains supply conductor connections to the terminal
block within the terminal box , please ensure that minimum clearances
are being maintained between individual conductors and conductors/
connectors to the adjacent metal surfaces of the terminal box itself ,
where possible add heat shrink sleeves to any bare conductor end/
connectors prior to securing.
