Installation
5
WARNING!
Please follow the points below when
installing the appliance
Use an Authorised Person
Installation should be carried out according to the
instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to
a wrong installation.
Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
Refer to data plate for rating information. The
data plate is positioned behind the bottom of the
oven door. The circuit diagram is positioned on
the top panel of the appliance.
A functional switch should be provided near the
appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1
Wiring should be protected against mechanical
failure. Refer to AS/NZS 3000 clause 1.5
A means of disconnection with a contact
separation of at least 3mm must be supplied in
the fixed wiring. Always turn the grill off
immediately after use as fat left behind may
catch fire.
Unplug the power plug of appliance from socket
before installation or any adjustment or
maintenance.
This Appliance Must Be Properly Earthed
Do not lift the appliance by the door handles.
Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
Slide appliance into the cupboard, ensuring that
the supply cable (where fitted) does not kink.
To prevent tipping, secure your oven into the
cupboard by fastening with 2 screws supplied.
Where the appliance is built into a cabinet, the
cabinet must be capable of withstanding 70°C.
Installation into low temperature tolerant
cabinetry (e.g. Vinyl coated) may result in
deterioration of the low temperature coating by
discoloring or bubbling.
The unit panels next to the appliance must be
heat resistant. In the case of veneered wood
units, glue must be resistant to a temperature of
120
°
C.
If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit
available from the vinyl-wrap supplier.
GSM cannot accept responsibility for damage
caused by installation into low temperature
tolerant cabinets.
After installation, test and ensure that the
appliance operates correctly before handing it
over to the customer.
Once the appliance is installed, there must be no
possible contact with electrical parts. Any
protective parts must can only be removed with
the use of tools
If a power point is fitted, it must be accessible
with the appliance installed, as the plug must be
accessible after installation
To avoid any potential hazard, you must
follow our instructions when you install
your appliance. Failure to install the
appliance correctly could invalidate any
warranty or liability claims and lead to
prosecution.
Install the shelf
1. Pay attention to high temperature, you may need
to wear gloves if it is hot inside.
2. Always slide shelves into the layer with stopper.
GSM Retail Australia
Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: 1300 373 199
Aust OR 0508123108 NZ
www.belliniappliances.com.au
Model: BOT605BX-F 60cm Built In Oven
