
9
Installation Instructions
Check for Gas Soundness
Gas pressure should be checked on a semi-rapid hob burner.
Remove the injector and fit the pressure test nipple supplied.
Light the other four burners and both ovens, then note the pressure.
This should be as stated on the rating label.
Note:
Replace the injector after checking.
Retain the test nipple in a safe place for future use.
Check the operation of the cooker
Check that the five hotplate electrodes spark correctly. The hotplate burners
should be checked for a steady flame (when turned down to the smallest flame
setting marked on the control panel).
Check that the large oven sparks correctly by turning the control knob to mark 9.
The burner should ignite within five seconds at low rate and increase to full rate
within sixty seconds. Leave the oven full on with the door closed for ten minutes
and then check that the flame reduces when the control knob is turned to the ‘E’
setting.
Check that the small oven sparks correctly by turning the control knob to mark 9.
The burner should ignite within five seconds at low rate and increase to full rate
within sixty seconds. Leave the oven full on with the door closed for ten minutes
and then check that the flame reduces when the control knob is turned to the ‘E’
setting.
Before you cook for the first time, we recommend that you turn on each element
and hotplate in turn to burn off any odors remaining from manufacture. Simply
operate each hotplate and the grill on maximum for a few minutes and each oven
for about 30 minutes.
User
Instruct the user in the operation of the appliance and hand over the instructions.
Содержание Db1000 Series
Страница 12: ...12 Know Your Cooker Plint...