Belling Db1000 Series, Инструкция по установке и эксплуатации, Страница: 6 / 35

6
Installation Instructions
Unpacking After unpacking your cooker, make sure that you remove all the packing from the
grill compartment and ovens, and any stickers from the oven doors and the hob.
Examine your cooker for any damage. If there is any damage to your cooker or
anything is missing, please contact your supplier for advice.
Siting/Moving the Cooker
Your cooker is heavy, so be careful when moving or positioning it. Do not try to
move the cooker by pulling on the doors or handles or control panel. The Belling
platinum db2 is designed to 'slot-in' between 600mm deep cabinets, spaced at
least 1000mm apart. It can also be used freestanding, with a cabinet to one side,
in a corner setting or with its back to a wall. However it must not be situated with
either side closer than 50mm to a combustible wall or cupboard that is higher than
the cooker. The wall behind the cooker and 450mm above and across the width of
the cooker, should be of an incombustible material or easy clean surface such as
ceramic tiles. Please note, when positioning your cooker against a wall, ensure
there is sufficient clearance for the screw heads on the back panel.
This appliance is designed not to project in front of standard 600mm worktops
(excluding handles). To achieve the best fit the cooker must be pushed against the
wall. If the wall mounted adaptor backplate (Fig.1) is to be fitted behind the
appliance then the suitable area for this fitting is shown as the area in (Fig.2).
Fig. 1 Fig. 2
ADAPTER BACKPLATE
ELBOW
ELBOW BAYONET
SOCKET
15mm COPPER
PIPE
MAINS INLET ON
APPLIANCE