Bellfires Tunnel 3, Инструкция по использованию и ежедневному обслуживанию, Страница: 17 / 112

17
Bell  res
English
Instructions for use
• Press button (large ! ame) to increase the ! ame level and to turn on the burner
from the stand-by position.
(Pressing brie! y the (large ! ame) button gradually increases the ! ames to the
high position.)
Pressing the (large ! ame) button twice automatically increases the ! ames to the
high position. This is indicated by “HI” on the display.
Important: • If you turn on the main burner by pressing the (large ! ame)
button, it must ignite within 10 seconds.
If this does not happen, immediately close the gas tap and
warn the " tter.
• If the main burner ignites with a pop; immediately close the gas
tap and warn the " tter.
Switching off the appliance
• Press the (small ! ame) button to lower the ! ames or to switch off the main burner.
• Then press the
OFF button to switch off the appliance, including the pilot light.
• Press the “ O I ” switch (on the gas control block) to the “ O ” position. This conserves
battery life.
• If the appliance is not to be used for some time, please close the gas supply valve in
the gas pipe.
Important: If the pilot ! ame goes out for any reason,
wait for 5 minutes before attempting to
re-light it.
Faults
• If the signals from the hand-held transmitter do not seem to be reaching the receiver,
the cause may be:
* Spent batteries: replace the batteries.
* An electronic problem: press the “
RESET ” button on the receiver.
• If the appliance regularly switches itself off, please contact your installer.
Replacing the batteries
• The hand-held transmitter/receiver batteries have a service life of approx. one year.
We recommend you use alkaline batteries.
Rechargeable batteries are not permitted.
• The batteries must be replaced whenever:
1 Hand-held transmitter : The battery symbol indicates this in the display.
: Battery fully charged
: Battery empty
2 Receiver: 3x short audio signal, audible when the motor-knob operates.