Belleze 014-HG-PH00, Руководство пользователя

Страница: 22 / 24

22
CARE AND MAINTENANCE
• Before servicing or cleaning, make sure the heater has been cool down.
⚠
WARNING
Cleaning The Exterior Surface
Storage (Between Uses)
Storage (During Long Period of Inactivity)
1. Use warm soapy water to clean the surface. DO NOT use any flammable or corrosive cleanin
agents.
2. Clean the burner holes using a heavy duty pipe cleaner. Make sure no spider or insect or their
nest is inside the heater.
3. Disassemble the reflector from the heater to wash and clean. Make sure to clean any carbo
deposits.
NOTE: A more frequent maintenance should be performed if the heater is being used in salty
environment. Make sure no corrosion in the unit. High quality automotive wax can be used to
maintenance the surface of the heater. DO NOT apply wax to the flame screen or reflect or.
⚠
WARNING: Make sure the burner
is
dry at all time. DO NOT submerge the control box
assembly. If the gas control is submerged in water, DO NOT use and must be replaced
1. Make sure control knob and cylinder valve are “OFF”.
2. Disconnect the LP cylinder.
3. Store heater upright in an area away from direct contact with inclement weather such as rain,
sleet, hail, snow, dust, and debris.
4. If desired, cover up the heater to prevent debris build up in air passages.
NOTE: Make sure the heater is cool down before covering.
1. Make sure control knob and cylinder valve are “OFF”.
2. Disconnect the LP cylinder. DO NOT leave LP cylinder under direct sunlight or excessive heat.
3. Store heater upright in an area away from direct contact with inclement weather such as rain,
sleet, hail, snow, dust, and debris.
4. If desired, cover up the heater to prevent debris build up in air passages.
NOTE: Make sure the heater is cool down before covering.
Regular maintenance should be performed to ensure the heater is in perfect working condition.
Visually checking portions of the hose assembly located within the confines of the heater post.
Inspect the entire hose assembly at least annually, disassembling the reflector and burner. Inspect
the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be
leak tested. Then assembling the reflector and burner again following with step 5 and 9 .