SPV26
8
English
Fig.3
Oil level
4 - OPERATING THE MACHINE FOR THE FIRST TIME
Never use the log splitter if it is not in perfect order or if it needs servicing. Before starting work, check correct functioning of all the safety
devices (ZHB, switch-off button on electric machines).
Before starting work, check the level of the hydraulic oil in the tank and top up if necessary
with one of the oils indicated on page 5.
The level of the oil must be between the two notches on the rod of the oil plug.
Before starting work, switch on the log splitter and let the oil warm up for a few minutes.
After 200 hours of use, clean the oil filter as explained on page 13 paragraph 6.1 before starting the machine.
4.1.A - For machines with electric motor...
If the motor does not run in the correct direction, invert two of the phases in the socket.
Remove the plug from the log splitter. Insert a slotted screwdriver with a suitably sized
wedge in the slot located in the connection inlet close to the electric motor as shown in
figure 4. Exerting a slight pressure, turn the white wheel by 180°. This operation physically
inverts the poles on the three-phase motor.
Check that the motor runs in the correct direction as indicated by the arrow.
I
Never open the box containing the switch, or open the terminal block on the
motor. if it is necessary to do so, have these operations carried out by your
electrician.
If the fuses blow or the protection valve trips, this means that you are overloading the motor
or the electrical installation is not correctly rated. Consult your electrician.
4.1.B - For machines with petrol or diesel engine...
Before operating the log splitter, carefully read the users manual for the engine fitted. study the maintenance regulations and guarantee
supplied.
Check the oil level in the engine block. top up if necessary.
WARNING
: working without oil causes irreparable damage.
When the engine is new, it is important, at first start-up, to let it turn over without performing any work for at least twenty minutes. this running-
in period ensures maximum performance and smooth operation of the whole system.
4.1.C - For machines with connection to the hydraulic system of the tractor (IT)
·
Make sure the tractor is off, that the parking brake is on and if necessary that the wheels are chocked.
·
Before starting work, always check that none of the hydraulic tubes is damaged.
·
Connect the oil delivery tube (marked with a special flat white clip) of the log splitter and the discharge tube (no marking) to the hydraulic
system of the tractor.
·
Make certain that all unions are tight and that there is no leakage of oil.
·
Apply a pressure not exceeding 220 bar to the hydraulic circuit of the log splitter.
·
Perform a few cycles without wood before starting work so as to vent any air present in the hydraulic circuit.
·
When disconnecting the machine from the hydraulic system of the tractor, take care not to spill any oil, and to replace the plugs on the two
tube unions.
Fig.4
Inversion of the poles in the three-
phase motor
