SPV26
6
English
3 - SAFETY
The information given in the chapter is extremely important for safety purposes. It describes possible hazards tied to use of the
machine and instructions for correct use of this to avoid injury or damage.
WARNING
: The BELL Mod. SPV26 log splitter has been designed and manufactured to split logs of the sizes recommended on page 5 only.
Use of the machine for any other purpose shall be considered improper and the manufacturer shall not be liable for any injuries or
damage to be ascribed to improper use of the machine.
The operator must work in the position shown in fig. 1 only and operate the machine drive control with both hands without using other
makeshift systems and without tampering with the ZHB control.
When the machine is working, persons and animals must be kept at a distance of at least 5 meters from the machine.
NEVER ATTEMPT TO TAMPER WITH THE PROTECTIONS OF THE LOG SPLITTER OR TO OPERATE THE MACHINE WITHOUT THESE.
FAILURE TO COMPLY WITH THE INSTRUCTIONS GIVEN IN THIS CHAPTER MAY RESULT IN SERIOUS INJURY OR DAMAGE TO
PERSONS, THINGS AND TO THE MACHINE.
3.1 - General safety regulations
·
The machine must always be used by one operator only.
·
Nobody must be allowed to use the log splitter unless they have read the instruction manual and have been instructed in the regulations to
follow for correct and safe use.
·
The machine must be used by adults only. Use of the log splitter by apprentices of not less than 16 years of age must be supervised by an
adult authorised to use the machine.
·
Never wear loose, unbuttoned clothing which may become trapped in moving parts.
·
Do not move the log splitter while the motor is running.
·
Do not work on sloping or slippery ground. position the machine in a flat area free from objects which may impede the freedom of
movement of the operator.
·
Check that the logs to be split are free from nails or wire, which may fly up or damage the machine. the ends of the logs must be cut
square. branches must be cut off flush with the trunk.
·
Never try to split logs larger than those indicated in fig. 2. This could be dangerous and may damage the machine.
·
Break wood in the direction of the grain. do not place wood across the log splitter and leave it in that position for splitting; it may be
dangerous and may seriously damage the machine.
·
Never attempt to cut two logs at once; one may fly up and hit you.
·
If the log moves away from the blade, retract the ram or the blade and turn the log through 90°.
·
Do not attempt to load the log in the log splitter while the ram is in motion. you could get trapped and injured.
·
Keep your hands well away from any splits and cracks which open in the log; these may close suddenly and crush or amputate your
fingers.
·
Do not force the log splitter for more than 30 seconds by keeping the cylinder under pressure at the end of its stroke, or by persisting when
a log does not split or gets stuck on the blade. Oil under pressure overheats very rapidly, damaging the pump.
·
Never leave the machine unattended while it is running. If you leave the machine, even for a short time, remove the power supply or any
possible cause of accidental start-up.
·
The log splitter must never be used by an operator who is under the influence of alcohol, drugs, medicines, or who is tired. A clear mind is
essential for safety.
·
Never try to release a jammed log while the machine is running. The machine must be switched off during this operation.
·
Never request the assistance of another person to help you remove a jammed log.
