46
Step 4: Configuring your Belkin Wireless Cable/DSL Router
(the Router) for connection to the Internet
Finishing PPPoE Setup
At this point, initial setup of the Router is now complete for a PPPoE
configuration. To verify that your Router is connected to the modem, Click
on “Status” in the lower left hand corner of the router setup page. The
status page shows you a variety of information about the Router’s current
state. Under the heading “INTERNET”, the connection status is displayed
as “Cable/DSL :” The word “Connected” will appear if the Router is
connected to the Internet, this indicates that initial setup was successful.
To
Browse the Internet
To begin browsing the Internet, log out of the setup utility by clicking on
the “Logout” button. Typically, to connect to your Internet Service you
would use the software that is provided by your ISP. With the Router now
in place, you do not need to use this software to connect to the Internet.
Simply type a web address such as
www.belkin.com
into the browser’s
address bar. If the Router is set up properly, the browser should take you
to the web address you entered. Other computers you have connected to
the router should also have access to the Web. If you are having problems
connecting, you may need to uninstall the software that was provided to
you by your ISP. If problems persist, see the troubleshooting section of this
manual or contact Belkin’s technical support hotline.
