Belkin ePowerSwitch F1D001, Руководство пользователя

Страница: 20 / 40

16
16
adapter you may access the configuration menu as if you were
directly attached to it via the configuration port.
Moving cursor in telnet session is
tricky
. You need to select
VT100 cursor which is under Terminal | Preferences |
VT100 Arrows . After this setup, moving around menu system
is actually easier than in console setup mode.
Note: You must have previously configured at least the IP
address and router information locally in order to
successfully make a Telnet connection.
5.Setup via Ethernet Cascaded Cable
Before setup you need:
1. IP address: Get a valid IP address from administrator.
2. Ethernet Cascaded Cable. (Not Enclose)
The following steps guide you in connecting the ePowerSwitch
System through the Ethernet port
1. Assign your PC’s IP address to dedicated IP address -
216.87.151.1
2. Connect the ePowerSwitch’s Ethernet port and PC’s
network port with Ethernet cascaded cable.
3. Enter ePowerSwitch web default IP address-
216.87.151.196 by web browser, then Use Web browser to
set IP, gateway and subnet.