b. Verify that the extension cable has the same color code as both wallplates
c. Verify that 110VAC is available within 3ft of the wallplate installation locations for
power adapters
4. Installation:
a. With electrical junction box and conduit
i. Install electrical conduit and [2-port] junction boxes at the TX and RX
locations according to local electrical codes
ii. Pull AV360™ extension cable through the conduit using pull rod, fish
tape or pull line attached to pull cap
iii. Remove pull caps and connect ends of AV360™ extension cable to the
AV360™ wallplates.
iv. Connect power adaptors to AV360™ wallplates. If the electrical outlet
for the adaptor is behind the wall, route the cable through the wallplate
cover’s notch.
v. Attach AV360™ wallplates to junction box.
b. Without electrical junction box or conduit
i. Using the enclosed template, cut the wallplate hole into the wall at both
the TX and RX locations.
ii. Drill the mounting holes according to the template and insert wall
anchors screws
iii. Pull AV360™ extension cable from one wallplate hole to the other using
pull rod, fish tape or pull line attached to pull cap.
iv. Remove pull caps and connect ends of AV360™ extension cable to the
AV360™ wallplates.
v. Connect power adaptors to AV360™ wallplates. If the electrical outlet
for the adaptor is behind the wall, route the cable through the wallplate
cover’s notch.
vi. Attach AV360™ wallplates to the anchored holes on the wall.
5. Connect source and display to the respective wallplates. We recommend Belkin-brand
VGA, HDMI, Component, Composite and S-Video cables.
*Note: Prior to installing the wall plates, please verify that the location of wall plates is away
from any & all active power lines.
4.0
VGA and HDMI Wallplate Instructions
Belkin AV360™ powered wallplates have designated TX sticker for transmitter and RX sticker
for receiver on the individual wall plate:
o
Verify that both the VGA and HDMI source & player equipments share compatible
graphic output type and resolution.
o
HDMI wallplates will not upscale video to 1080p if the source is not rated 1080p.
o
VGA wallplates will not upscale beyond source graphic card capability.
o
Once the extension cable is connected to the TX and RX wallplate, plug in the power
adapter before turning on the source and player.
o
VGA wallplates: to make video adjustments, adjust the TX wallplate tuning button
first, and then the RX wallplate tuning button to fine tune video image.
o
HDMI wallplates are plug & play, no additional adjustments needed.
5.0
Troubleshooting
Problem:
I am getting ghosting, shadowing, or fuzzy images on my monitor.
Solution:
•
Check that all video cables are inserted properly.
