6
Assembling the 9 Inch Desk Fan
Assembling the Desk Fan
STEP 1: Remove the plastic rear grill locking nut by twisting it in an
anticlockwise direction.
STEP 2: Place the rear grill over the motor assembly pin so that it is aligned
with the four plastic pins.
STEP 3: Add the grill locking nut, twisting it in a clockwise direction to secure
the rear grill into position.
STEP 4: Place the fan blade unit onto the motor assembly and push until it is
locked into position.
STEP 5: Open the clips around the outer edge of the front grill and position it
onto the rear grill. Fasten the clips around the outer edge of the front grill to
lock the grills into position, so that the blade and motor unit are protected.
STEP 6: Insert the grill screw through the hole at the bottom of the front and
rear grill, then place the nut onto the grill screw and tighten it in a clockwise
direction to secure the grills together.
Note: Do not overtighten the rear grill locking nut.
Instructions for Use
Before connecting to the mains power supply, place the assembled desk fan
onto a flat, stable surface, allowing for sufficient distance between the desk fan
and any objects that could get damaged or caught in the rotating fan blades.
Using the 9 Inch Desk Fan
STEP 1: Plug in and switch on the desk fan at the mains power supply.
STEP 2: To turn on the desk fan, select the desired cooling speed by pressing
‘1’or ‘2’. Speed setting ‘1’ is the lowest cooling speed setting; ‘2’ is highest
cooling speed setting.
STEP 3: To tilt the fan head, position as desired. The locking mechanism will
hold the head in the set orientation.
STEP 4: Activate the oscillation function by pushing the oscillation switch; the
desk fan will begin to oscillate. To stop the desk fan from oscillating, pull up the
oscillation switch.
STEP 5: Turn off the desk fan by pressing ‘0’.
Caution: Do not cover the fan head.
