Belden HIRSCHMANN EAGLE40, Руководство пользователя

Страница: 26 / 52

26
Installation EAGLE40
Release 02 08/2020

Voltage not potential-separated

Supported file system: FAT32
Note: Please note that in EAGLE40-07 devices, you can currently only use
1 of the 2 USB interfaces. Which one of the USB interfaces you decide to use
does not make a difference.
1.9 Input/output interfaces
1.9.1 Signal contact
The signal contact is a potential-free relay contact.The device allows you to
perform remote diagnosis via the signal contact. In the process, the device
signals events such as a line interruption. When an event occurs, the device
opens the relay contact and interrupts the closed circuit. The management
setting specifies which events switch a contact.You can also use the
management to switch the signal contact manually and thus control external
devices.
1.9.2 Digital input (optional)
The support of the function is dependent on the software release. Software
support for the function is unimplemented at the time of printing this manual.
Figure 2: Input: 2-pin terminal block with screw locking
The digital input allows you to capture and forward signals from digital
sensors. In the configuration, you specify how the device uses the digital
input.
Figure Pin Operation
1 VCC (VBus)
2 − Data
3 + Data
4 Ground (GND)
Table 6: Pin assignment of the USB interface
1 2 4 3