Belden grass valley KALEIDO-MX 4K, Руководство по описанию оборудования и инструкция по установке, Страница: 26 / 52

26
Installation
Maintenance
GPI-I/O connector layout
For ease of connection, you may use the GPI-1501-TBA terminal block adapter with integral
44-pin connector. Refer to the
GPI-1501 Guide to Installation and Operation (available on the
Kaleido-X DVD that shipped with your system, and from the Documentation Library section
of Grass Valley’s website), for more information. Refer to the
Kaleido-X User’s Manual for
detailed instructions on configuring a GPI-1501 within your multiviewer system.
Maintenance
Replacing Cards
All cards and rear panels can be installed with the frame power on. Each card has a
connector which plugs into the frame’s backplane for distribution of power and connection
to the controller card, and one or two connectors (depending on the card type) that plug
into the rear panel for inputs and outputs.
Removing a card
To remove a card
1 Open the front door of the frame (see Opening the front door , on page 20).
2 Tilt the swivel handle, on the front of the card you wish to remove, to lever the
connectors apart, and then use the handle to pull the card straight out of the slot.
3 Close the front door of the frame (see Closing the front door , on page 20).
Installing a card
To install a card in a Kaleido-MX 4K (1RU)
1 Open the front door of the frame (see Opening the front door , on page 20).
2 To install a card into an empty slot, slide the card into the slot, with the swivel handle to
the right, and push gently on the handle to seat the connectors. Inserting the card into
the wrong slot will not damage the card, and will be flagged by the on-card status LED
flashing to indicate that there is no connection to the rear panel.
3 Close the front door of the frame (see Closing the front door , on page 20).
Note:
Removing more than one input card from a Kaleido-MX 4K system in
operation is not supported.