Belden grass valley KALEIDO-MX 4K, Руководство по описанию оборудования и инструкция по установке, Страница: 20 / 52

20
Installation
Handling the Front Door
Handling the Front Door
The front door of the Kaleido-MX 4K (1RU) frame is fastened in place by two captive
thumbscrews, one at each end of the door.
Opening the front door
To open the door
• Turn both thumbscrews counterclockwise until they release, and then pull the door
away from the front of the frame.
The door is attached to the frame by guides that slide out of the frame as the door is
pulled, and allow the door to be lowered below the frame so that cards and power
supplies can be removed and installed.
Removing the front door
To remove the door
• Slip the ends of the guides off the posts on the door assembly.
Closing the front door
To close the door
• Slide it into position against the front of the frame, and then turn the captive
thumbscrews clockwise until the door is securely fastened into place.
Mounting the Kaleido-MX 4K in a Rack
The Kaleido-MX 4K (1RU) housing frame occupies 1RU, in a standard 19-inch rack.
To mount the frame
1 Open the front door to expose the rack mounting flanges at the ends of the chassis (see
Opening the front door , on page 20).
2 Install the frame in the rack using 4 standard rack-mounting screws (not supplied)
through the four holes in the mounting flanges.
Note:
You must tilt the door on an angle so the guides can move freely.
There are no electrical connections to the door.