29
Kaleido-IP X310/X110
Installation & Service Manual
9 Under
General
, type a descriptive name for your system to make it readily identifiable.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
10 Under
Ethernet
, type the appropriate IP addresses, network masks, and gateway
settings, and review the detected connection speeds and duplex modes for your
Kaleido-IP’s network adapters.
Note:
The system name must comply with RFC 1123, because it is also used
as the device’s host name. Up to 8 characters are allowed, limited to A-Z, a-z,
0-9, and the hyphen character. The system name cannot start or end with a
hyphen character.
Management IP
address
Must be within the network to which the Kaleido-RCP2 units, and
the operators’ PCs or laptops are normally connected.
Data port
The IP address for a data port must be within the same range as the
associated streaming devices (e.g. encoders, multiplexers).
To omit network configuration for an unused data port, clear the
corresponding
Enabled
check box.
Network mask
Must be set to the appropriate values, for the management and data
networks.
Содержание Grass Valley KALEIDO-IP X110
