Densité 3 Frame |
5
2.5 Installing Densité 2 Cards and Rear Modules in a Densité 3 Frame
The Densité 3 frame supports the many Grass Valley Densité 2 series cards. Should you need to install a
Densité 2 card in your Densité 3 frame, you will need two adapters – one for the card, and one for the rear
panel. These adapters extend the height of the Densité 2 devices so that they will fit into the slots of the 3 RU
Densité 3 frame.
Card adapters:
There are 3 different types of adapters that can
be used, depending on the Densité 2 card
geometry:
o
DENSITE 3-EXT-A
o
DENSITE 3-EXT-B
o
DENSITE 3-EXT-C
Install these on the Densité 2
card as follows:
1. Fit the top edge of the card into the
holding slot along the bottom edge of the
adapter.
2. Align the holes in the top of the card with
the holes on the adapter, and secure them
together with the two provided screws and
lock washers, as shown in the figure.
Rear adapters:
3-RU rear module adapters are available
for Single and Double Densité 2
rear
modules:
o
DENSITE DRP-3RU
o
DENSITE SRP-3RU
Install these as follows:
1. Position the adapter at the top of the
empty slot(s) on the rear of the frame.
2. Use the captive screw in the adapter
to fasten it securely in position.
