MV-800 User Manual
Initial Checks and Actions
MV-800 Hardware Installation 3.2
Issue 2 Revision 1
Page 23
© 2019 Grass Valley, a Belden Brand
3.2.4 Fitting of Video SFPs to MV-800 Rear Panel
Before fitting the MV-800 Rear Panel (1312) into the router frame, first fit any SFP video
modules, if this has not already been done. This sub-section provides SFP video module fitting
guidelines.
Before inserting the SFP modules, take notice of the required SFP orientation for fitting into the
SFP cages of the MV-800 Rear Panel, as shown in Figure 12.
Note:
It is possible to hot-plug SFP modules but this is not recommended
here.
Because it is easier and more practical to fit them to the MV-800 Rear
Panel before it is fitted into the router frame.
Figure 10 Coax and fiber SFP video modules
Note:
The normal orientation of the MV-800 1312 Rear Panel in the router has
the printed circuit board upper-most, see Figure 11. This affects the
orientation of each SFP when fitting into the target router.
Figure 11 1312 MV-800 Rear Panel orientation, showing “INSERT THIS SIDE UP” label.
INSERT THIS SIDE UP label
