BEL STEWART 298007X-01 CRIMP TOOL Complete with dies
From MN290008 Rev A3
5.
Maintenance and general remarks
Crimping handtool 298007x-01 is intended to be used for crimping of SS-39200-0xx modular plugs.
Using this handtool for any other purpose, or for crimping of any other objects, can result in damaging the tool
and the objects being crimped and prevention of its normal further functioning, for what manufacturer cannot
be held responsible.
Handtool is equipped with full cycle ratchet mechanism which with optimized leverage system within the tools
make working with these tools easy and simple. In case of improper crimp, ratchet release mechanism allows
you to easily open the handtool and remove obstruction before work is continued. Check unblocking procedure
(item 3.).
Tool itself also incorporates possibility of periodical adjustment of the crimping force and tool recalibration via
eccentric axle to maintain correct crimp performance. Check tool regulation procedure (item 4.).
For removal of dust, moisture and other contaminants usage of clean brush or soft, lint-free cloth is
recommended. Do not use aggressive agents (thinner, alcohol etc…) or hard objects that could damage the tool.
Make sure that during the work bearing surfaces, shafts and pivot points are protected with thin coat
of quality machine or motor oil. Do not oil excessively.
When the tool is not in use, store it in a closed position – with handles closed. That will keep other
objects from becoming stuck between crimping dies and damaging them. Keep the tool in a dry and
clean area.
Use only original spare parts.
6.
Spare Die sets
For Cat6 cables:
NSR-XXXXX BEL STEWART 2980076-01 Die set (6.1-6.6mm OD) for 2980075-01 tool
NSR-XXXXX BEL STEWART 2980077-01 Shield crimp insert (6.1-6.6mm OD) for 2980075-01 tool
For Cat6A cables:
NSR-40608 BEL STEWART 2980073-01 Die set (6.8-7.5mm OD) for 2980078-01 tool
NSR-XXXXX BEL STEWART 2980074-01 Shield crimp insert (6.8-7.5mm OD) for 2980078-01 tool
