42 / EN
Washing Machine / User’s Manual
4.1 Installation
• Apply to the nearest authorized service agent for the installation of your product.
• Preparation of the location and electrical, tap water and waste water installations at the place of installation
is under customer's responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or
crushed while pushing the product into its place after installation or cleaning procedures.
• Make sure that the installation and electrical connections of the product are performed by authorized
service agent. The manufacturer shall not be held liable for damages that may arise from procedures
carried out by unauthorised persons.
• Prior to installation, visually check if the product has any defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
• Operate the product in a well ventilated and dust free environment.
4.1.1 Appropriate installation location
• Place the product on a solid and level floor. Do not place it onto a carpet with high pile or other similar
surfaces.
• Total weight of the washing machine and the dryer -with full load- when they are placed on top of each
other reaches to approx. 180 kilograms. Place the product on a solid and flat floor that has sufficient load
carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where temperature may fall below 0ºC.
• Leave a minimum space of 1.5 cm between the product and the furniture.
• If you will install the product on a surface with steps, never place it close to the edge.
• Do not place the product on any platform.
• Do not place heat sources such as Hobs, Irons, Ovens, etc. on the washing machine and do not use them
on the product.
4.1.2 Removing packaging reinforcement
Tilt the product backwards to remove the packaging reinforcement.
Remove the packaging reinforcement by pulling the ribbon. Do not make
this operation alone by yourself.
4.1.3 Removing transportation safety bolts
1
Loosen all transportation safety bolts with an appropriate wrench until they turn freely.
2
Remove transportation safety bolts by turning them gently.
3
Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel.
Содержание WTZ101435BI
Страница 34: ......
Страница 35: ...2820525943_EN 30 04 18 11 55 Washing Machine User s Manual WTZ101435BI EN Document Number ...
Страница 67: ......
Страница 68: ...www beko com ...