Beko WTV 9745 X0A, Руководство пользователя, Страница: 90 / 96

90 / EN
Washing Machine / User’s Manual
Problem Cause Solution
Loading door cannot be
opened.
Loading door lock is activated because of the
water level in the product.
• Drain the water by running the Pump
or Spin programme.
Product is heating up the water or it is at the
spinning cycle.
• Wait until the programme completes.
Loading door may be stuck because of the
pressure it is subjected to.
• Grab the handle and push and pull the
loading door to release and open it.
If there is no power, loading door of the product
will not open.
• To open the loading door, open the
pump filter cap and pull down the
emergency handle positioned at the
rear side of the said cap. See “Loading
door lock”
The door of the machine might not open due to
safety reasons.
• If the door remains locked at the
end of the programme when the
Wash&Wear function is selected, this
means that the door will be locked
until the machine gets cold for safety
reasons.
Washing takes longer than
specified in the user manual.
(*)
Water pressure is low.
• Product waits until taking in adequate
amount of water to prevent poor
washing quality due to the decreased
amount of water. Therefore, the
washing time extends.
Voltage is low.
• Washing time is prolonged to avoid
poor washing results when the supply
voltage is low.
Input temperature of water is low. • Required time to heat up the water
extends in cold seasons. Also, washing
time can be lengthened to avoid poor
washing results.
Number of rinses and/or amount of rinse water
have increased.
• Product increases the amount of rinse
water when good rinsing is needed
and adds an extra rinsing step if
necessary.
Excessive foam has occurred and automatic foam
absorption system has been activated due to too
much detergent usage.
• Use recommended amount of
detergent.
Programme time does not
countdown. (On models with
display) (*)
Timer may stop during water intake. • Timer indicator will not countdown
until the product takes in adequate
amount of water. The product will
wait until there is sufficient amount
of water to avoid poor washing results
due to lack of water. Timer indicator
will resume countdown after this.
Timer may stop during heating step.
• Timer indicator will not countdown
until the product reaches the selected
temperature.
Timer may stop during spinning step.
• Automatic unbalanced load detection
system is activated due to the
unbalanced distribution of the laundry
in the product.
Programme time does not
countdown. (*)
There is unbalanced load in the product. • Automatic unbalanced load detection
system is activated due to the
unbalanced distribution of the laundry
in the product.