8 / EN
4.1.4 Connecting water supply
C
The
water
supply
pressure
required
to
run
the
product
is
between
1
to
10
bars
(0.1
–
1
MPa).
It
is
necessary
to
have
10
–
80
liters
of
water
flowing
from
the
fully
open
tap
in
one
minute
to
have
your
machine
run
smoothly.
Attach
a
pressure reducing valve if water pressure is higher.
A
CAUTION:
Models with a single water inlet should not be connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch to protection mode and will not operate.
CAUTION:
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1 Tighten the nuts of the hose by hand. Never use a tool when
tightening the nuts.
2 When hose connection is completed, check whether there is
leak problems at the connection points by opening the taps
fully. If any leaks occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking the seal. In order to
prevent the water leaks and resultant damages, keep the taps
closed when you do not use the product.
4.1.5 Connecting the drain hose to the drain
•
Attach
the
end
of
the
drain
hose
directly
to
waste
water
drain,
lavatory
or
bathtub.
A
CAUTION:
Your drain house will be flooded if the hose comes out of its housing during water discharge.
Moreover, there is risk of scalding due to high washing temperatures! In order to prevent such situations and
make sure that the machine performs water intake and discharge processes without any problem, fix the drain
hose securely.
•
Connect
the
drain
hose
to
a
minimum
height
of
40
cm and a maximum height of 100 cm.
•
In
case
the
drain
hose
is
elevated
after
laying
it
on
the floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
•
To
prevent
the
waste
water
to
go
back
into
the
machine
again
and
to
ensure
easy
drainage,
do
not
immerse the end of the hose into the waste water or do not insert it into the drain for more than
15 cm. If it is too long, cut it short.
•
The
end
of
the
hose
should
not
be
bent,
it
should
not
be
stepped
on
and
the
hose
must
not
be
pinched between the drain and the machine.
•
If
the
length
of
the
hose
is
too
short,
use
it
by
adding
an
original
extension
hose.
Length
of
the
hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the
extension hose and the drain hose of the product must be fitted well with an appropriate clamp as
not to come off and leak.
Содержание WTG841B3B
Страница 1: ...2302061198 Washing Machine User Manual WTG841B3B EN Document Number ...
Страница 37: ......