7 / EN
Washing Machine / User’s Manual
2.5 Connecting to the drain
• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A
CAUTION:
Your house will be flooded if the
hose comes out of its housing during water
discharge. Moreover, there is risk of scalding due
to high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of the
discharge hose tightly so that it cannot come out.
• The hose should be attached to a height of at least
40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on the
floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
100cm
40cm
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do not
drive it in the drain more than 15 cm. If it is too long,
cut it short.
• The end of the hose should not be bent, it should
not be stepped on and the hose must not be
pinched between the drain and the machine.
• If the length of the hose is too short, use it by adding
an original extension hose. Length of the hose
may not be longer than 3.2 m. To avoid water leak
failures, the connection between the extension hose
and the drain hose of the product must be fitted well
with an appropriate clamp as not to come off and
leak.
2.6 Adjusting the feet
A
CAUTION:
In order to ensure that the product
operates more silently and vibration-free, it must
stand level and balanced on its feet. Balance
the machine by adjusting the feet. Otherwise,
the product may move from its place and cause
crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
WARNING:
Do not use any tools to loosen the
lock nuts. Otherwise, they will get damaged.
2.7 Electrical connection
Connect the product to a grounded outlet protected
by a 16 A fuse. Our company shall not be liable for
any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after
installation.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
B
DANGER:
Damaged power cables must be
replaced by the Authorized Service Agents.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply connections.
3. Drain all water that has remained in the product.
4. Install transportation safety bolts in the reverse order
of removal procedure;
C
NOTE :
Never move the product without the
transportation safety bolts properly fixed in place!
A
CAUTION:
Packaging materials are dangerous
to children. Keep packaging materials in a safe
place away from reach of the children.
