Beko WMY 71441PTL, Руководство пользователя

Страница: 28 / 38

28 / EN
Washing Machine / User’s Manual
Maintenance and cleaning
6.4 Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at the
end of each water intake hose where they are
connected to the tap. These filters prevent foreign
substances and dirt in the water to enter the
washing machine. Filters should be cleaned as
they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to
access the filters on the water intake valves.
Clean them with an appropriate brush. If the
filters are too dirty, remove them from their
places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water
intake hoses together with the gaskets and
clean thoroughly under running water.
4. Replace the seals and filters carefully and
tighten their nuts by hand.
6.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in case
of freezing of the water, water may have to be
drained completely.
A
CAUTION:
Foreign substances left in the
pump filter may damage your machine or
may cause noise problem.
CAUTION:
If the product is not being
used, shut the tap shut, remove mains
pipe and drain the water inside the
machine against any likely freezing.
CAUTION:
After each use, turn off the
water tap to which the mains hose is
connected.
In order to clean the dirty filter and discharge
the water:
1 Unplug the machine to cut off the supply power.
A
CAUTION:
Temperature of the water
inside the machine may rise up to 90 ºC.
To avoid the burning risk, clean the filter
after the water inside the machine is
cooled down.
2. Open the filter cover.
3. While some of our products are equipped with
an emergency water drain hose, some are not.
Follow the below procedures in order to drain
water.