Beko WMY 71441PTL, Руководство пользователя

Страница: 11 / 38

Washing Machine / User’s Manual
11 / EN
Installation
3.4 Connecting water supply
C
The water supply pressure required to run
the product is between 1 to 10 bars (0.1 –
10 MPa). It is necessary to have 10 – 80
liters of water flowing from the fully open
tap in one minute to have your machine run
smoothly. Attach a pressure reducing valve
if water pressure is higher.
If you are going to use the double water-
inlet product as a single
(cold)
water-inlet
unit, you must install the supplied stopper
to the hot water valve before operating the
product. (Applies for the products supplied
with a blind stopper group.)
A
CAUTION:
Models with a single water
inlet should not be connected to the hot
water tap. In such a case the laundry will
get damaged or the product will switch to
protection mode and will not operate.
CAUTION:
Do not use old or used water
inlet hoses on the new product. It may
cause stains on your laundry.
Connect the special hoses
supplied with the product to the
water inlets on the product. Red
hose (left) (max. 90 ºC) is for
hot water inlet, blue hose (right)
(max. 25 ºC) is for cold water
inlet.
A
CAUTION:
Make sure that the hot and cold
water taps are connected correctly when
the product is being installed. Otherwise,
your laundry will come out hot at the end of
the washing process and wear out.
1 Tighten the nuts of the hose by hand. Never use
a tool when tightening the nuts.
2 When hose connection is completed, check
whether there is leak problems at the
connection points by opening the taps fully. If
any leaks occur, turn off the tap and remove the
nut. Retighten the nut carefully after checking
the seal. In order to prevent the water leaks and
resultant damages, keep the taps closed when
you do not use the product.
3.5 Connecting to the drain
• Attach the end of the drain hose directly to
waste water drain, lavatory or bathtub.
A
CAUTION:
Your house will be flooded
if the hose comes out of its housing
during water discharge. Moreover, there
is risk of scalding due to high washing
temperatures! In order to prevent such
situations and make sure that the machine
performs water intake and discharge
processes without any problem, fix the
drain hose securely.
• Connect the hose to a minimum height of 40 cm
and a maximum height of 100 cm.
• If the hose is placed at floor level or near to floor
(less than 40 cm) and heightened later on, water
drain becomes difficult and laundry may come
out extremely wet. Therefore, follow the heights
described in the figure.
100cm
40cm
• To prevent the waste water to go back into the
machine again and to ensure easy drainage, do
not immerse the end of the hose into the waste
water or do not insert it into the drain for more
than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it
should not be stepped on and the hose must not
be pinched between the drain and the machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.