Beko WMI 71241, Инструкция по технике безопасности

Страница: 15 / 73

15
EN
at which the programme was cancelled remains lit.
" END " appears on the display and the programme
is cancelled.
C
If you want to open the loading door after
you have cancelled the programme but it
is not possible to open the loading door
since the water level in the machine is above
the loading door opening, then turn the
Programme Selection knob to Pump+Spin
programme and discharge the water in the
machine.
Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol illuminates
when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine
is in this mode:
Adjust the spin speed and press Start / Pause
/ Cancel button. Pause symbol disappears and
Start symbol appears. Programme resumes,
discharges the water and spins the laundry.
If you only want to drain the water without
spinning:
Just press Start / Pause / Cancel button. Pause
symbol disappears. Start symbol appears.
Programme resumes and discharges the water
only.
End of programme
“End” appears on the display at the end of the
programme. Symbols of the programme steps
remain lit. Auxiliary function, spin speed and
temperature that were selected at the beginning of
the programme remain selected.
You can remove the detergent drawer by pulling it
towards yourself strongly.
C
If more than a normal amount of softener and
liquid detergent mixture starts to remain in the
softener compartment, the siphon must be
cleaned.
Wash the drawer and the siphon with plenty of
lukewarm water in a washbasin. Wear protective
gloves or use an appropriate brush to avoid
touching the residues in the drawer when cleaning.
Replace the drawer into its housing after cleaning.
Check if the siphon is in its original location.
Cleaning the loading door and the drum
Residues of softener, detergent and dirt may
accumulate in your machine in time and may
cause unpleasant odours and washing complaints.
To avoid this, use the Drum Cleaning programme.
If your machine is not featured with Drum Cleaning
programme, use Cottons-90 programme and
select Additional Water or Extra Rinse auxiliary
functions as well. Before starting the programme,
put max. 100 g of powder anti-limescale into the
main wash detergent compartment (compartment
nr. II). If the anti-limescale is in tablet form, put only
one tablet into compartment nr. II. Dry the inside
of the bellow with a clean piece of cloth after the
programme has come to an end.
C
Repeat Drum Cleaning process in every 2
months.
C
Use an anti-limescale suitable for the washing
machines.
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
C
Foreign metal substances in your machine
will cause rust stains. Clean the stains on the
drum surface by using cleaning agents for
stainless steel. Never use steel wool or wire
wool.
Cleaning the body and control panel
Wipe the body of the machine with soapy water
or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
A
Never use sponge or scrub materials. These
will damage the painted and plastic surfaces.
5 Maintenance and cleaning
Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.
Cleaning the detergent drawer
Remove any powder residue buildup in the
drawer. To do this;
1
2
3
4