8 / EN
Washing Machine / User Manual
Adjusting the feet with water level
• You must remove the Detergent Drawer to
set the Water Level.
• For the system to operate properly, the bubble
inside the Water Level must be in the
middle
.
• If the bubble inside the Water Level is on the
left
, the pre-set
right
foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the
right
, the pre-set
left
foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at the
back
, the pre-set
front
feet of the Washing
Machine must be turned to the left (clockwise).
• If the bubble inside the Water Level is at the
front
, the pre-set
front
feet of the Washing
Machine must be turned to the right (anti-
clockwise).
4.1.7 Electrical connection
Connect the product to a grounded outlet
protected by a 16 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
• Damaged power cables must be replaced
by the Authorised Service Agents.
4.1.8 Initial use
Before starting to
use the product
make sure that
the preparations
are made which
are in line with the
“Important Safety
and Environment Instructions” and the
instructions in the “Installation” section.
To prepare the product for washing laundry,
perform first operation in Drum Cleaning
programme. If this program is not available
in your machine, apply the method which is
described in the section 4.4.2.
C
INFORMATION
• Use an anti-limescale suitable
for the washing machines.
• Some water might have remained
in the product due to the quality
control processes in the production.
It is not harmful for the product.
