Beko METPOINT BDL compact, Инструкция по установке и эксплуатации

Страница: 61 / 118

EN Installation and operating manual
METPOINT
®
BDL compact 61
11.2.2.10. Type "Modbus"
11.2.2.10.1. Selecting and activating sensor type
Step 1: select a free sensor channel
Home  Settings  Sensor settings  A1
Step 2: select Modbus type
Home

Settings

Sensor-settings

A1

Type

Modbus
Step 3: confirm with OK
Enter a name (see chapter 11.2.2.7 “Labelling and configuring text fields”).
Home  Settings  Sensor-settings  A1  right arrow (2. page)  VA  use
Via Modbus, up to 8 register values (from the input
or holding registers) of the sensor can be read out.
Select one or more registers ( Va –Vh ) and activate
by checking the use box.
11.2.2.10.2. General Modbus settings
Home  Settings  Sensor-settings  A1  right arrow (2. page)  Modbus settings  ID
Enter the Modbus ID of the sensor; available values:
1 – 247 . (e.g. Modbus ID = 12 )
Enter all serial transmission settings such as baud
rate , stop bit , parity bit and timeout .
If the METPOINT
®
BDL compact is connected to
the bus terminal, press the Term button to activate
termination. You also have the option to press the
Bias button to use a BIAS.
Confirm the changes with OK .
To reset the values to the default settings, press the
Default values button.
The Modbus ID and the transmission settings are
specified in the sensor data sheet.