6 / EN
Washing Machine / User’s Manual
2.3 Removing the transportation locks
A
WARNING
Do not remove the transportation
locks before taking out the packaging
reinforcement.
Remove the transportation safety bolts
before operating the washing machine!
Otherwise, the product will be damaged.
Loosen all the bolts with a suitable spanner
until they rotate freely (C). Remove
transportation safety bolts by turning them
gently. Attach the plastic covers supplied in
the User Manual bag into the holes on the rear
panel. (P)
C
INFORMATIONS
Keep the transportation safety bolts in a safe
place to reuse when the washing machine
needs to be moved again in the future.
Never move the product without the
transportation safety bolts properly fixed in
place!
2.4 Connecting water supply
C
INFORMATIONS
The water supply pressure required to run
the product is between 1 to 10 bars (0.1 – 1
MPa). It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in one
minute to have your machine run smoothly.
Attach a pressure reducing valve if water
pressure is higher.
If you are going to use the double water-
inlet product as a single (cold) water-inlet
unit, you must install the supplied stopper
to the hot water valve before operating the
product. (Applies for the products supplied
with a blind stopper group.)
If you want to use both water inlets of the
product, connect the hot water hose after
removing the stopper and gasket group
from the hot water valve. (Applies for the
products supplied with a blind stopper
group.)
A
WARNING
Models with a single water inlet should not
be connected to the hot water tap. In such
a case the laundry will get damaged or the
product will switch to protection mode and
will not operate.
Do not use old or used water inlet hoses on
the new product. It may cause stains on your
laundry.
Connect the special hoses supplied with the
product to the water inlets on the product. Red
hose (left) (max. 90 ºC) is for hot water inlet,
blue hose (right) (max. 25 ºC) is for cold water
inlet.
A
WARNING
Ensure that the cold and hot water
connections are made correctly when
installing the product. Otherwise, your
laundry will come out hot at the end of the
washing process and wear out.
Tighten all hose nuts by hand. Never use
a wrench when tightening the nuts. Open
the taps completely after making the hose
