Beko CM 10121 BB, Руководство пользователя

Страница: 35 / 44

EN / 35
Product directly drains the water it
takes in.
• Draining hose is not at adequate height.
>>> Connect the water draining hose as
described in the user manual.
No water can be seen in the product
during washing.
• Water is inside the invisible part of the
product. >>> This is not a failure.
Loading door cannot be opened.
• Loading door lock is activated because of
the water level in the product. >>> Drain
the water by running the Pump or Spin
programme.
• Product is heating up the water or it is at
the spinning cycle. >>> Wait until the pro-
gramme completes.
• Loading door may be stuck because of
the pressure it is subjected to. >>> Grab
the handle and push and pull the loading
door to release and open it.
• If there is no power, loading door of the
product will not open. >>> To open the
loading door, open the pump filter cap and
pull down the emergency handle posi-
tioned at the rear side of the said cap. See
Loading Door Lock [
}
30]
Washing takes longer than specified in
the user manual. (*)
• Water pressure is low. >>> Product waits
until taking in adequate amount of water to
prevent poor washing quality due to the
decreased amount of water. Therefore, the
washing time extends.
• Voltage is low. >>> Washing time is pro-
longed to avoid poor washing results
when the supply voltage is low.
• Input temperature of water is low. >>> Re-
quired time to heat up the water extends
in cold seasons. Also, washing time can
be lengthened to avoid poor washing res-
ults.
• Number of rinses and/or amount of rinsing
water have increased. >>> Product in-
creases the amount of rinsing water when
good rinsing is needed and adds an extra
rinsing step if necessary.
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
Programme duration does not count-
down. (On models with display) (*)
• Timer may stop during water intake. >>>
Timer indicator will not countdown until the
product takes in adequate amount of wa-
ter. The product will wait until there is suffi-
cient amount of water to avoid poor wash-
ing results due to lack of water. Timer in-
dicator will resume countdown after this.
• Timer may stop during heating step. >>>
Timer indicator will not countdown until the
product reaches the selected temperature.
• Timer may stop during spinning step. >>>
Automatic unbalanced load detection sys-
tem is activated due to the unbalanced
distribution of the laundry in the product.
Programme duration does not count-
down. (*)
• There is unbalanced load in the product.
>>> Automatic unbalanced load detection
system is activated due to the unbalanced
distribution of the laundry in the product.
Product does not switch to spinning
step. (*)
• There is unbalanced load in the product.
>>> Automatic unbalanced load detection
system is activated due to the unbalanced
distribution of the laundry in the product.
• The product will not spin if water is not
drained completely. >>> Check the filter
and the draining hose.
• Excessive foam has occurred and auto-
matic foam absorption system has been
activated due to too much detergent us-
age. >>> Use recommended amount of
detergent.
Washing performance is poor: Laundry
turns gray. (**)
• Insufficient amount of detergent has been
used over a long period of time. >>> Use
the recommended amount of detergent
appropriate for water hardness and the
laundry.